43. Remove the decals from the Decal Sheet (not shown) and apply them to the PRO 9545 as shown in the dia-
gram below.
10
44. Make sure that all parts are correctly assembled and tightened. Use of the remaining parts will be explained
in HOW TO USE THE WEIDER
®
PRO 9545, beginning on page 18 of this manual.
Before using the PRO 9545, pull the end of each cable a few times to make sure that the cables move
smoothly. If the cables bind, correct the problem before using the PRO 9545. See the CABLE DIAGRAMS
on pages 22 and 23 of this manual to make sure that the cables are properly routed. IMPORTANT: If the
cables have been incorrectly routed, they will be damaged when heavy weight is used.
43
11
12
19
19
30
17
17
42
32
32
18
108
24
Lubricate
Small Hole
30
30
24
34
Bent End
32
30
29
29
30
30
68
27
92
93
Lubricate
6
33
10. Make sure that there are two Long 3/4” Flange
Bushings (18) in the indicated side of the
Butterfly Arm Frame (42).
Tap two 1 3/4” x 1 3/4” Inner Caps (24) into one
of the Butterfly Arms (30) as shown.
Slide an Adjustment Bracket (32) onto the axle on
the Butterfly Arm (30). Turn the Adjustment
Bracket so the indicated small hole is on the side
shown. Make sure that there is a Short 3/4”
Flange Bushing (108) in the Adjustment
Bracket, and that the flange of the Bushing is
on top.
Apply lubricant to the axle on the Butterfly Arm
(30). Insert the axle into the indicated hole in the
Butterfly Arm Frame (42). Tap two 3/4” Retainers
(17) and a 3/4” Retainer Cap (19) onto the end of
the axle. Note: The teeth on the Retainers
must bend toward the Retainer Cap as shown
in the inset drawing.
Assemble the other Butterfly Arm (30) and
Adjustment Bracket (32) in the same manner.
11. Attach the bent end of a Link Arm (33) to the
small hole in one of the Adjustment Brackets (32)
with a 3/8” x 1” Bolt (6), a 3/8” Plastic Washer
(34), and a 3/8” Nylon Locknut (27) as shown.
Lubricate a 1/4” x 1 1/4” Bolt (93). Attach the
other end of the Link Arm (33) to the Pivot Arm
Tube (92) with the 1/4” x 1 1/4” Bolt and a 1/4”
Nylon Locknut (68).
Attach the other Link Arm (33) to the other
Adjustment Bracket (32) in the same manner (not
shown).
12. Wet the lower ends of both Butterfly Arms (30)
and the insides of the two Long Foam Pads (29)
with soapy water. Slide a Long Foam Pad onto
each Butterfly Arm.
8
17
SQUAT/MILITARY
COMBO
RANGE OF MOTION
PRO 9545
BUTTERFLY
HIGH PULLEY
VERTICAL KNEE RAISE
LOW PULLEY
LEG
EXTENSION
PRESS ARM
