10
14.
Locate and open the parts bag labeled ÒCABLE
ASSEMBLY AND PULLEYS.Ó For Cable identifica-
tion and routing during steps 14Ð28, refer to the
Cable Diagram and Cable ID Chart on page 16.
Locate the Short Cable (9). It is approximately 127Ò
long. Wrap the end with the ball around a 3 1/2Ó
Pulley (35) in the direction shown.
Attach the 3 1/2Ó Pulley to the Top Frame (1) with a
3/8Ó x 3 1/2Ó Bolt (54), a 3/8Ó Flat Washer (55) and a
3/8Ó Nylon Locknut (63).
Make sure the Short Cable (9) is between the
Pulley (35) and the welded hook (K) on the Top
Frame (1).
14
Cable Assembly
1
63
54
9
55
35
K
13. Press a 1 1/2Ó Square Inner Cap (33) into the Leg
Lever (29).
Lubricate a 5/16Ó x 2 1/2Ó Bolt (22). Attach the Leg
Lever (29) to the Seat Frame (36) with the Bolt and a
5/16Ó Nylon Jamnut (80).
Do not overtighten the
Nylon Jamnut. The Leg Lever should pivot freely.
Thread a 5/16Ó Plain Nut (32) one half inch onto the
5/16Ó x 2Ó Eyebolt (44). Thread the Eyebolt into the
Leg Lever (29). Tighten the Plain Nut to prevent the
Eyebolt from turning.
Note: The use of remaining parts from the ARM
ASSEMBLY parts bag will be explained in step 31.
13
29
44
32
33
36
22 Lubricate
80
15. Wrap the Short Cable (9) around a ÒVÓ-Pulley (6) in
the direction shown.
Attach the ÒVÓ-Pulley (6) and a Long Cable Trap (50)
to the indicated bracket (J) with a 3/8Ó x 2 1/4Ó Bolt
(65) and a 3/8Ó Nylon Locknut (63).
Make sure the
Long Cable Trap is positioned as shown, so it will
hold the Cable in place.
15
J
65
9
50
6
63
