8
7.
Slide two 5/16Ó Flat Washers (56) onto two
5/16Ó x 1 3/4Ó Bolts (58).
Align the holes in the bracket on the Top Frame (1)
with the holes in the Rear Upright (18). Insert the
5/16Ó x 1 3/4Ó Bolts (58) and hand tighten two 5/16Ó
Nylon Locknuts (53) onto them.
7
8.
Attach the upper ends of the Weight Guides (23) to
the bracket (D) on the Top Frame (1) with two 5/16Ó x
1 1/2Ó Bolts (61) and two 5/16Ó Nylon Locknuts (53).
Tighten the Nylon Locknuts, but be careful not to
overtighten them since this may damage the weight
guides.
8
53
1
D
61
23
9.
Press a 1 1/2Ó Square Inner Cap (33) into the end of
the Seat Frame (36).
Insert two 5/16Ó x 2 3/4Ó Bolts (67) through the
Support Plate (27) and the indicated holes in the
Front Upright (42). Place the mounting bracket (E) on
the Seat Frame (36) over the two Bolts. Tighten a
5/16Ó Nylon Locknut (53) onto each Bolt.
Make sure the Support Plate (27) is oriented as
shown in the drawing.
Tighten all Nylon Locknuts used in steps 3
through 9.
9
67
53
42
36
E
27
53
33
10.
Locate and open the parts bag labeled ÒARM
ASSEMBLY.Ó
Press Arm Assembly.
Align the welded spacers on
the Press Frame (12) with the tube (F) on the Base
(8). Lubricate the 3/8Ó x 8Ó Bolt (59). Attach the Press
Frame to the Base with the Bolt and a 3/8Ó Nylon
Locknut (63).
10
Arm Assembly
59 Lubricate
Welded Spacers
12
63
8
F
58
1
18
56
53
