34
63
63. Attach the hook on the Burn Band (26) to
the High or Low Anchor (C, D) on the Burn
Cable (45).
64. Make sure that all parts are properly tightened. The use of the remaining parts will be explained in
ADJUSTMENT, beginning on page 35.
Before using the weight system, pull each cable a few times to make sure that the cables move smoothly
around the pulleys. If one of the cables does not move smoothly, find and correct the problem.
IMPORTANT: If the cables are not properly installed, they may be damaged when heavy weight is
used. See the CABLE DIAGRAM on page 39 for proper cable routing. If there is any slack in the
cables, you will need to remove the slack by tightening the cables. See MAINTENANCE on page 41.
26
45
Hook
C
D
62
62. Insert a Pulley (69) under the High Cable (44) in
the location shown.
Attach the Pulley (69) inside the Top Frame
(6) with an M10 x 65mm Bolt (75), two M10
Washers (88), two 12.7mm Spacers (73), and an
M10 Locknut (74).
69
44
73
88
75
73
88
74
6
Summary of Contents for 831.14923.1
Page 40: ...40 NOTES...
