18
36. Attach the Press Bracket (94) to the Leg
Press Arm (96) with a 5/16Ó x 3Ó Bolt (75) and
a 5/16Ó Nylon Locknut (3).
Wrap the Leg Press Cable (99) around a 3 1/2Ó
Pulley (15). Attach the Pulley to the Press
Bracket (94) with the 3/8Ó x 2Ó Bolt (12) and a
3/8Ó Nylon Locknut (21).
Slide a 5/16Ó Flat Washer (8) onto a 5/16Ó x
2 3/4Ó Bolt (11). Insert the Bolt through the
lowest hole in the Rear Seat Frame (100)
from the indicated side. (Note: The three
holes are for cable adjustment.) Tighten a
5/16Ó Nylon Jam Nut (93) onto the Bolt. Slide
the end of the Leg Press Cable (99) onto the
end of the Bolt. Thread another 5/16Ó Nylon
Jam Nut onto the Bolt.
Do not fully tighten
the second Jam Nut. There must be room
between the two Jam Nuts for the end of
the Cable to pivot.
37.
Locate and open the parts bag labeled
ÒSEAT ASSEMBLY.Ó
Insert a 1/4Ó x 2 1/2Ó Carriage Bolt (92)
through the center hole in a Seat Plate (37).
Attach the Seat Plate to the Rear Backrest
(85) with two 1/4Ó x 1/2Ó Screws (18).
Insert the 1/4Ó x 2 1/2Ó Carriage Bolt (92)
through the indicated hole in the Leg Press
Upright (56). Tighten a 1/4Ó Nylon Locknut (2)
with a 1/4Ó Flat Washer (10) onto the Carriage
Bolt. Attach the top of the Rear Backrest (85)
to the Leg Press Upright with a 1/4Ó x 2 1/2Ó
Screw (43) and a 1/4Ó Flat Washer (10).
38. Attach one end of a Seat (13) to the Rear
Seat Frame (100) with two 1/4Ó x 1/2Ó Screws
(18). Attach the other end of the Seat to the
Rear Seat Frame with a 1/4Ó Flat Washer (10)
and a 1/4Ó x 2 1/2Ó Screw (43).
38
36
37
CABLE ASSEMBL
Y
SEA
T ASSEMBL
Y
11
75
96
94
12
21
100
93
85
56
92
18
18
43
2
10
100
43
13
8
3
99
10
37
15
