55
Control.ini
Each time value must be entered in the format
minutes:seconds. Hours must be converted to minutes. A time
of 2 hours, 15 minutes and 20 seconds should be formatted as
135:20.
The character after the "
t
" determines the way the time
should be interpreted.
m
is the absolute time after powering on the ProCommander
®
AX or after the insertion of a
card. After each removal
or new insertion of the card the time is set to zero.
&
means "modulo" which means, that any time the value is
reached the command is executed.
Example:
!tm01:20!…#
-> if the time 1 minute 20 seconds is reached
after the start-up or plug in of the card, then the downstream
command will be executed.
!t&05:00!…#
-> all 5 minutes the downstream command
will be executed.
8.1.3 !v: Variable events
For basic information about the variables read the chapter
".
After each change of a variable the Control.ini file is checked,
if an event is assigned to this variable.
If this variable condition is true, the following command will
be executed.
Summary of Contents for ProCommander AX
