28
Repair information and repair instructions
3. Remove the decoupling tube including the
insert.
5. Remove the display
Attaching the display
1. Glue new foam
2. Insert the new display.
3. Tighten the screw
using the spring
4. Attach the decoupling tube.
– Connect the decoupling tube to the box.
– Insert the decoupling tube including the
insert.
– Tighten the screw
firmly,
but not too tight.
Note:
If the screws are too tight it may
become difficult to install the cover
.
5. Insert the main circuit board (chapter 7.6,
6. Close the unit (chapter 7.5, page 24).
7. Check that everything is working properly
7.10 Replacing the baffle box
1. Open the unit (chapter 7.4, page 23).
2. Remove the main circuit board (“7.6
Replacing the main circuit board” on
page 25, steps
Remove the baffle box
2. Remove the box
