Repair information and repair instructions
21
7. Repair information and repair instructions
7.1 General
Please perform repairs on SOMNO
comfort
2/SOMNO
comfort
2e/SOMNO
balance
/SOMNO
balance
e
at an ESD workstation!
•
Refer to the safety instructions in the instructions
for use for SOMNO
comfort
2/
SOMNO
comfort
2e/SOMNO
balance
/
SOMNO
balance
e.
• Any handling of this device requires in-depth
knowledge of and adherence to the
instructions for use and the servicing and
repair instructions.
• Perform repairs described in this servicing and
repair instructions only. This is the only way to
ensure that SOMNO
comfort
2/
SOMNO
comfort
2e/SOMNO
balance
/
SOMNO
balance
e work properly.
• Make sure that your hands and your
workspace are clean when performing
repairs.
• After
every
repair a servicing check must be
performed (see “5. Final test” on page 15).
• When replacing components or single parts,
use genuine Weinmann replacement parts
only.
• When ordering the unit’s lower part of the
housing
you have to state unit type, built
and serial number.
Note:
The item numbers stated in the following text are
identical with the item numbers of the Replacement
parts list on page 33 and the overview on page 4.
7.2 Tools and facilities
In order to perform the repairs described in this chapter, you will need the following tools and facilities:
• Torx Screwdriver T 20
• Phillips screwdriver PZ 2
• Ball-headed Allen wrench 3 mm
• Knife with a flat smooth blade for removing the front panel foil
• Scissors or scalpel for removing motor mounts
• Nail scissors or ticket-punch to mark the servicing plaque
• ESD Workstation
