©
2017 WEINZIERL ENGINEERING GmbH
Page 8/8
IP). In the ETS, the routing interface appears if at least one de-
vice on the network which supports routing is available. The
name of the network interface appears in the PC as description.
If routing is selected as interface, the programming is done from
the ETS project as like with other devices. In this case LAN is
used as a KNX medium like TP. There is no additional interface
device required.
Via direct IP connection
While KNXnet/IP Tunneling and KNXnet/IP Routing is limited to
the speed of KNX TP the device can be loaded via a direct IP
connection at high speed. The direct IP connection is possible if
the device already has a valid IP configuration as well as an indi-
vidual address. To do this select "Use direct IP connection if
available" in the ETS menu "Bus
– Connections - Options". The
download is then directly performed in the device and is not visi-
ble in the ETS group monitor.
Due to the significantly shorter transmission times it is
recommended to perform downloads via IP.
Weinzierl Engineering GmbH
D-84508 Burgkirchen / Alz
Germany
http://www.weinzierl.de
info@weinzierl.de
WARNING
The device must be mounted and commis-
sioned by an authorized electrician.
The prevailing safety rules must be heeded.
The device must not be opened.
For planning and construction of electric in-
stallations, the relevant guidelines, regulations
and standards of the respective country are to
be considered.
The device is a permanently connected equip-
ment: A readily accessible disconnect device
shall be incorporated external to the equip-
ment.
The installation requires a 16 A fuse for exter-
nal overcurrent protection.
The power rating is indicated on the side of
the product.
Weinzierl Engineering GmbH
D-84508 Burgkirchen / Alz
Germany
http://www.weinzierl.de
info@weinzierl.de
2017/02/14
