©
2019 WEINZIERL ENGINEERING GmbH
Page 2/8
1.
Direct setting/status display on device
A. Startup and idle display
During startup of the device, the physical
address and the status of the application
is displayed.
The device name “KNX PS 367” can be
changed within ETS parameter settings.
The status can be one of the following values:
Running:
Application is loaded and running
Stopped:
The application is stopped-
❺
LED for
Programming Mode is flashing
Unloaded:
The application is not loaded -
❺
LED
for Programming Mode is flashing
Loading:
The application is currently loading
Overload:
The output current is above the max.
limit (900mA) -
❺
LED for Programming Mode is
flashing
USB:
USB Connection established
USB local:
local download via USB is executed
The power supply functionality (KNX and auxiliary voltage) is
not dependent whether the application is running or not.
After 10 minutes of inactivity the display will turn into
screensaver mode (blank screen with a bouncing dot) to
safe display life time. Press any key to turn the display
on again. The activation of the display can be synchro-
nized between all devices of this device line of Weinzierl
via a group object. See parameter section for details.
Local download via USB
The internal application can be loaded both with an additional
interface via the KNX bus or locally via the integrated USB inter-
face. When using an additional interface the download is done
conventionally but there may not be any USB connection on
KNX Power Supply USB 367.
For local download via the integrated USB interface, the follow-
ing differences should be noted:
Reaction with the ETS 5.5
via ETS menu
“connection/interfaces”
Physical address
Possible without programming
mode but no automatic adoption
into ETS project (see picture of
ETS below)
via projec
t “programming“
Physical address &
application program
The complete download is
executed over the bus at slow
speed. The change of the physi-
cal address may not be taken
over with the connection and
may cause inconsistencies later
on.
Partial
The download is executed
automatically at high speed.
Physical address
The download is executed over
the bus.
The change of the physical
address may not be taken over
with the connection.
Application program
The download is executed
automatically at high speed.
The integrated USB Interface does not support the bus
monitor mode.
Setting of local addresses
in the ETS menu “connec-
tion / Interfaces”
Local download in the ETS 5.5
