The Weir Group PLC
Weir Industrial Gateway setup guide rev 0.5
Copyright © Weir Minerals Australia Ltd 2017. Commercial in Confidence. All rights reserved.
Page
33
of
46
14.213.2
Hazardous Location Non-Incendive sensors
The RSP provides non-incendive field wiring outputs for Class 1 Division 2 hazardous
location environments, groups B, C, D, E, and F. The non-incendive field wiring outputs are
rated to the following parameters:
Parameter
Value
Voltage V
O
24V
Current I
O
Power P
O
Capacitance C
O
Inductance L
O
WARNING
: EXPLOSION HAZARD. DO NOT CONNECT OR DISCONNECT SENSORS
WHEN ENERGIZED IN A HAZARDOUS LOCATION ENVIRONMENT.
AVERTISSEMENT
—
NE PAS CONNECTER OU DÉCONNECTER LES CAPTEURS DE
SONDAGE QUAND IL EST ENERGISE DANS UN ENVIRONNEMENT DE LOCALISATION
DANGEREUSE
.
14.313.3
Sensor Install Locations
The following diagram shows the locations that sensors can be placed on a liquid pump.
Figure 13-1 Sensor Install Locations