3.2 THE INSTRUMENT INSTALLATION
ATTENTION: The instrument is to be installed in such a way: it is not directly
exposed under the sunlight or up to 60
℃
. The microphone should be placed at
the sufficient distance from noisy machines, loudspeakers, sharp stroke sound
and particularly from ultrasonic cleaners. The high noise will disturb signal
input from the microphone. If the instrument is equipped with a printer, then it
should also be far away the printer.
3.2.1 THE POWER SUPPLY INSTALLATION
Plug the power cable into the outlet. Power supply voltage is 100 - 240V~.
3.2.2 THE MICROPHONE CONNECTION
Connect the sensor plugs with the host sensor connector.
3.2.3 THE PRINTR CONNECTION
Connect the plug of thermal printer with the host interface.
(The connection is unnecessary if no printer)
4. OPERATION
The instrument automatic start to work after power-on, some parameters set
by the user don’t store after power-down, and can be return to factory
settings when you power on again.
Place the watch on the signal sensor and watch crown should touch on the
sheet metal. Test orientation can be changed freely, and the hand should
remove from the sensor after confirmation test orientation. The Green LED is
flashing, meaning that it has received the watch signal.
