© COPYRIGHT Weiss Ltd 2020. All rights reserved
Weiss Limited reserves the right to alter designs and specifications
without notice and without obligation
FV604
Revision 03.0 210520
GENERAL USE AND SAFETY INFORMATION
Thank you for purchasing this quality
Heat Transfer System
product by Weiss.
With a Weiss
Heat Transfer System
selected rooms can be warmed by transferring heat from an area with a
slow combustion fire as the main heat source. This product is not designed for use with a heat pump.
NOTE: THESE UPDATED INSTALLATION AND OPERATION INSTRUCTIONS SUPERSEDE ANY INSTRUCTIONS ON THE
CARTON or other FITTING INSTRUCTIONS
PLEASE READ ALL INSTRUCTIONS CAREFULLY BEFORE COMMENCING INSTALLATION.
Note
: Pictures and diagrams on packaging are designed only to be used as a concept. All installation
details should be carried out as per the instructions herein.
Note
:
THIS PRODUCT MUST BE WIRED BY A REGISTERED ELECTRICIAN
SUITABILITY
Heat Transfer System
can be installed into any rooms that require warmth to ward off winter chills. The subtle
design and quiet operation make the unit suitable for hallways, bedrooms and other family areas. Not for
use in kitchens and bathrooms.
Heat Transfer System
(includes insulated ducting, controller and inline fan) has been designed for ceiling
cavity installation.
BEFORE YOU START
Heat Transfer System
must not be mounted in areas subject to direct splashing. Refer to New Zealand
standard NZECP2: 1988 Section 4.6 and Australian Standard AS3000:1991, Section 6.2.
SAFETY NOTE
This appliance is not intended for use by persons (including children) with reduced physical, sensory or
mental capabilities, or lack of experience and knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person responsible for their safety. Children should be
supervised to ensure that they do not play with the appliance.
To avoid a hazard, a damaged supply cord must be replaced by the manufacturer. This includes the
removal of the supply cord as this appliance is supplied as compliant. Modification including removal of the
plug or cutting of the supply cord will render unit NON-COMPLIANT.
Precautions must be taken to avoid the back-flow of gases into the room from the open flue of gas or other
fuel-burning appliances. Ensure that the fan is switched off from the supply mains before removing the
guard.
Weiss recommends you always operate this product with the supplied controller and do not leave running
overnight. The fan will turn itself off when the temperature dips below the set point in the heat source room.
Before the fan is connected to a power circuit, ensure all electrical and building codes are adhered to.
INSTALLATION INFORMATION
IMPORTANT
Decide on which rooms you want to warm and check the distances between these rooms (in a straight line)
to check your overall ducting requirement.
The Weiss
Heat Transfer Systems
are
not heat generating systems
. The systems have been designed to
transfer heat. To ensure that minimal heat is lost while being transferred from one room to another, the
ducting included is fully insulated.
Be sure that you have sufficient surplus heat available to be transferred to additional rooms.
Fit all duct work and secure the fan unit prior to the connection of the electrical supply.
DUCTING
All ducting components that are required to duct your
Heat Transfer System
are included. A total ducting
length of 24 metres is included with this unit. (8 x 3 metre lengths).
FOR OPTIMUM PERFORMANCE
A well-insulated house with a ceiling height of 2.4 meters will be the most effective with a Weiss
Heat Transfer
System
. You may have to run your Heat Source at a higher setting to be able to transfer the extra heat
created to other rooms. When starting the system, set the controller to the temperature that is required to
be maintained in the room with the main heat source (the room with the controller). This means that surplus
