OPERATING INSTRUCTIONS FOR GAMBIT DE-ESSER/COMPRESSOR DS1-MK2
TECHNICAL DATA
-
Weiss Engineering Ltd., Florastr. 42, CH-8610 Uster
Page 22 of 29
+41 1 940 20 06
2
+41 1 940 22 14
8
http://www.weiss.ch
*
weiss@weiss.ch
Remote
MIDI Implementation
System Inclusive
All band parameters plus the controls parameters are remote controllable. Each parameter has its corre-
sponding MIDI controller number.
According to the different parameters, the controllers are limited in their range. Invalid values are replaced
by the maximum allowable value. Following is a list of the supported MIDI commands:
Action
MIDI Message Status Byte Data Byte(s)
Comment
Restore Snapshot
Program Change
1100 cccc
0ppp pppp
(cccc) Channel No.
(ppppppp) New Prog No: 0 - 127
Center Frequency
Control Change
1011 cccc
00000000 ($00)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 – 105
Bandwidth
Control Change
1011 cccc
00000001($01)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 36
Filter Mode
Control Change
1011 cccc
00000010 ($02)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0= limiter, 1= Bandpass,
2 = Lowpass, 3 = Hipass
Preview Delay
Control Change
1011 cccc
00000011 ($03)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 32
Attack
Control Change
1011 cccc
00000100 ($04)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 43
Release Delay
Control Change
1011 cccc
00000101 ($05)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 53
Release Fast
Control Change
1011 cccc
00000110 ($06)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 53
Average
Control Change
1011 cccc
00000111 ($07)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 53
Release Slow
Control Change
1011 cccc
00001000 ($08)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 53
Soft Knee
Control Change
1011 cccc
00001001 ($09)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0 - 10
Gain Makeup Mode
Control Change
1011 cccc
00001010 ($0A)
(cccc) Channel No.
0vvv vvvv
(vvvvvvv) New Value:
0= off, 1 = manual, 2= maximum
