14.
Close the appliance door.
15.
Wait for the final wash cycle to finish (about 20 to 30 minutes depend-
ing on the cleaning profile).
16.
■
An audible signal is given when the final wash cycle is finished.
■
Follow the prompts displayed by the software.
17
■
Open the appliance door and check the cleaning result. The cooking
chamber should look clean and not smell of leftover food or cleaning
agents.
■
Check the cooking chamber for any foreign matter that may have
entered with the rinse water. Remove any foreign matter.
■
If the cleaning result is not good enough, either clean and rinse the
cooking chamber manually or run a cleaning profile again.
18.
Empty the condensate collecting tray from the loading trolley and rinse
it out with water.
19.
Leave the appliance door ajar to let the cooking chamber dry out.
How to perform fully automatic cooking chamber cleaning using single-measure dispensing bottles (easyDial)
1.
Select the cleaning profile and start the cleaning process.
2.
Wait for the soak cycle to finish (about 5 to 10 minutes depending on
the cleaning profile).
3.
■
An audible signal is given when the soak cycle is finished.
■
You are prompted to add the cleaning agent.
■
The software displays for you the number of single-measure dis-
pensing bottles required.
4.
Open the appliance door.
5.
Add the cleaning agent from the single-measure dispensing bottles to
the cooking chamber.
If necessary for this procedure, pull the loading trolley out of the cook-
ing chamber and then push it back into the cooking chamber after
adding the cleaning agent.
6.
Close the appliance door.
5 Cleaning procedures
User manual
72
