5.4.5 Emptying and cleaning the grease collecting canister (only applies to ConvoGrill)
For your safety when using the combi oven
Before starting work, it is essential that you familiarize yourself with the rules and hazard warnings specified in the chapter
'For your safety on page 18' and in this instruction manual, and follow the instructions given there.
Dealing with extracted grease/used grease
■
Used oil and used grease must be disposed of in accordance with national laws and regulations and in accordance with
regulations from local disposal companies and authorities.
■
Used grease must not be disposed of via the drain into the sewerage system.
■
Extracted grease/used grease must not be reused for food processing.
■
Collect the used grease in suitable collecting containers and take it to waste recycling.
■
Personnel must be trained by the owner of the combi oven.
Materials required
■
Large bottle brush
■
Common household detergent
■
Suitable collecting container for extracted grease (capacity >> 10 litres)
Properties of the grease collecting canister
Only the original grease collecting canister supplied must be used, because it is made of a material that meets the require-
ments for receiving hot fat.
Emptying and cleaning the grease collecting canister
1.
Remove the screw cap (1) and attached tube from the grease collect-
ing canister (2).
2.
Suspend the screw cap (1) and attached tube, with the tube mouth up-
permost, from the forked bracket (3). This prevents grease running out
onto the floor, making it dirty and slippery.
3.
Take care when handling the grease collecting canister (2) to avoid
grease spilling onto the floor, making it dirty and slippery. This is partic-
ularly important when carrying the open grease collecting canister (2)
when it is full.
Pour the extracted grease out of the grease collecting canister (2) into
the collecting container for extracted grease. When doing this, empty
the grease collecting canister (2) from the side to avoid the grease
slopping over.
4.
Clean the inside of the grease collecting canister (2) using cleaning
agent, plenty of hot water and the bottle brush.
5.
Rinse out the grease collecting canister (2) with water and let it drain
well.
6.
Screw the screw cap (1) and attached tube for the grease removal
system back onto the grease collecting canister (2).
7.
Place the grease collecting canister (2) upright beside the appliance
on a flat surface. The surface on which the canister (2) sits must not lie
more than 15 cm above the surface supporting the appliance. The us-
er's work area must not be obstructed.
5 Cleaning procedures
User manual
95
