Replacing the rinse aid canister
1.
Risk of irritation to skin, eyes and respiratory system
■
Do not let the rinse aid come into contact with skin, eyes or mucous
membranes.
■
Do not inhale vapours from the rinse aid.
■
Wear personal protective equipment.
Remove the cap from the ConvoCare rinse aid mixing canister.
2.
■
Locate the canister that is connected by the (green) tube to the rinse
aid connector (F) underneath the appliance on the left-hand side.
■
Unscrew the (green) supply tube (2) plus suction nozzle from the lo-
cated canister.
■
Remove the empty rinse aid canister.
3.
■
Place ready the new canister (1) filled with rinse aid.
■
Feed the (green) supply tube plus suction nozzle (2) into the full
canister (1) and screw it on.
■
Make sure that there are no kinks in the tube and that the vent hole
on the canister cap is unobstructed.
4.
■
Check the position of the canisters:
■
The surface on which the canisters sit must not lie above the level
at which the appliance feet meet the appliance case.
■
The surface on which the canisters sit must not lie more than 1
metre below this level.
■
Check that you have connected the tube to the correct connector.
■
The rinse aid must be attached to appliance connector F.
(The colour green is used throughout.)
5 Cleaning procedures
User manual
97