6-2 Connection
6-5
Chap.
6
6-2 Connection
6-2-1 Connection with a Host Computer
When connecting to a host computer, make certain you have the HIF-51 PC con-
nection cable (WRS-AXC003A) on hand.
1. Connect an communication cradle to a host
computer using the HIF-51 PC connection cable
(WRS-AXC003A).
2. Connect the AC adapter.
3. Turn ON the power switch on the back of the
communication cradle.
Once the CTR-800-11W has been prepared for data
transmission and reception, you can place the CTR-800-11W onto the unit
(HIF-51) and begin transmitting and receiving data. (P.4-32
、
4-34)
Please place the CTR-800-11W prepared for transmission and reception of data on
the communication cradle (HIF-51) when the power LED is green. If you place the
terminal onto the communication cradle (HIF-51) while the power LED is red,
transmission and reception will fail.
Please do not operate the CTR-800-11W while on the communication cradle (HIF-
51). The communication cradle may triple over or the CTR-800-11W may fall
from the unit, possibly causing a failure.
Please do not use the communication cradle near noise-emitting equipment, such
as a computer, fluorescent light etc.
Noise may cause incorrect communication.
Summary of Contents for CTR-800-11W
