Chapter 4 Settings
4-22
Chap.
4
4-6-2 TCP/IP Setup
Set an IP address and other details for TCP/IP communications. Automatic setup
is possible when the DHCP function (P.4-23) is enabled.
1. From the System Menu, select "2:Network."
2. Then select "2: TCP/IP."
3. To set the value, select the item you want to set up,
then press the
key. Then set the value which is
divided into four fields by a period.
Possible Setting Range
0 - 255
Example) 192.168.254.254
4. Once the new value is set, press the
key to
confirm the changes.
●
IP address
Set the IP address assigned by the network administrator. Set a unique IP
address to each of the CTR-800-11W terminals connected to the same network.
●
Subnet mask
Set the subnet mask assigned by the network administrator. Since a subnet
mask specifies which network you belong to, it should set up along with the IP
address.
●
Gateway
Set the address of the default gateway. Setup is required when connecting to a
different network through a router.
Please ask the network administrator about the value settings for different items.
When "3:Run at startup" ("4-6-3 DHCP Setup" (P.4-23) s selected, it is only veri-
fied and impossible to change.
< Network Config >
1:RF 5:DNS
2:TCP/IP
6:SNMP
3:DHCP 7:MAC
4:FTP
< TCP/IP >
1:IP address
2:Subnet Mask
3:Gateway
< TCP/IP >
1:IP
>192.168.254.254
2:Subnet Mask
3:Gateway
Summary of Contents for CTR-800-11W
