2–1
Quick Start Programming
2
QUICK START PROGRAMMING MENU
2.1 Introduction
Use this chapter to program the SCANTEAM 3210 Hand
Held CCD Scanner to work with your terminal/computer.
❖
About “Plug and Play” Programming
With “Plug and Play” programming (Section 2.2), you
connect the 3210 and scan
only one bar code to program
the scanner (including required prefixes/suffixes).
❖
About Terminal Selection Programming
With Terminal Selection programming (Section 2.3), you
program the 3210 for
any supported terminal/computer.
❖
Program Carriage Return (CR) Suffix
Use the single bar code in Section 2.4 to program a
carriage return suffix in the 3210.
❖
To Clear Bar Code Suffix
Use the single bar code in Section 2.5 to clear bar code
suffix in the programmed 3210.
❖
To Reset Factory Default Settings
Use the single bar code in Section 2.6 to reset the 3210
to factory default settings.
❖
Additional Programming Options
If you need additional programming options, refer to
Chapter 3 to
•
select factory default settings
•
change the programmable features available.
Note:
Before programming the 3210, follow instructions in
Chapter 1 to unpack and connect the scanner.
Summary of Contents for SCANTEAM 3210 Series
