4–7
Programming the Scanner
The code identifier for each bar code symbology is listed below and
appears immediately following the symbology name on the Symbology
Selection Menu Page.
SYMBOLOGY
CODE ID
Codabar
a
Code 3 of 9
b
UPC
c
EAN
d
Interleaved 2 of 5
e
Code 2 of 5
f
MSI
g
Code 11
h
Code 93
i
Code 128
j
Note:
Code 11 is not supported in all wand models/software revisions.
Postamble
Postamble(s) are programmable data identifiers which follow the bar code
messages. Up to five (5) postambles including End Transmission (ETX),
Carriage Return (CR), Line Feed (LF) and the ASCII characters (00– 7F)
can be programmed. Postamble characters will be transmitted in the order
in which they are selected. Since postamble selections also begin with a
clean slate, the programming sequence SCAN ENTER, SCAN IV, SCAN
EXIT will remove existing postambles from the decoder configuration.
Intercharacter Delay
An Intercharacter Delay may be assigned for outgoing messages. The
delay is in milliseconds and can be set to any value between 1 and 99. If
the Intercharacter Delay Variable “No” is programmed, the delay will be
set to 0.
Summary of Contents for Scanteam 6180
