3) After completion of treatment, please store the electrodes in a dry,
well-ventilated place for next use.
1) Adhesive electrodes should be always clean on their surfaces, without any dust,
oily or sticky substances; otherwise, their viscosity will decrease. If they become
dirty, please rinse them with clean water and then dry them in air for repeated use.
2) The adhesive electrodes could be used for about 80 times (20 minutes each
time). Please consider to purchase new ones from your local dealer or the
manufacturer if your electrodes still cannot restore their viscosity after a few
washes.
3) Please use adhesive electrodes attached with the product. Other types of
electrodes are prohibited. Adhesive electrodes attached with the product, with a
dimension of 52mm (Width) x 70mm (Height) x 2.5mm (Thickness) approximately,
are acceptable only. Please don't use those in other dimensions.
4) There are no limitations on special skills, training and knowledge of intended
operators or responsible organizations that use the product, and on service location
or environment of the main unit. Just follow the instructions for use.
Special education and training are not required for users to operate the product.
Just read and follow the instructions for use.
Note:
It is recommended to use the product twice a day, 15-30 minutes each time.
4.3 Use of batteries
1) 3 pieces of AALR6 batteries are required for the main unit for about 60 days of
service (based on 30 minutes each day).
2) 2 pieces of AAA batteries are needed for the remote control for about half a year
of service (based on 30 minutes each day).
3) When the main unit beeps three times continuously, it indicates a low battery
and the batteries need to be replaced with new ones.
4) When the remote control displays " ", it indicates a low battery. Please
replace with new batteries.
5) When the product is not in use for a long time, please remove the batteries,
otherwise a device malfunction may occur due to battery leakage.
6) Please don't use batteries other than externally specified.
7) Please pay attention to the positive ("+") and negative ("-") poles in mounting
batteries.
