2.Functional operation:
Wear the massager on the neck and have the electrodes against
the skin of the neck, press the " " button on the right handle to
switch on the massager, and the massager then enters the
standby state and the working light bar flows in a cycle from left
to right and then from right to left.
Press the " " key on the remote control to switch on the device,
and working LED is ON when the buzzer gives a "beep" sound.
At this point, the default program starts in the following mode:
the massager works in pulse mode "1", at "00" level, hot
compress works at medium "2" level, and the red light is started
simultaneously, with the timing set at 15 min; then you can
operate the remote control to adjust the desired massage
technique and intensity; when the main unit successfully
receives a signal by operating the remote control, a beep will
sound.
IV. Way of Operation
Notes:
III. Structure
75
76
1
2
3
4
5
6
7
8
9
1. Power supply:
• Powered by USB
Plug the output end of the USB cable into the lower hole in the
massager (power connector) and connect the USB power
supply for charging.
• Powered by lithium batteries
It can also be powered by the built-in rechargeable lithium
batteries.
2
4
7
1
9
6
8
5
3
Electric pulse
Heat moxibustion
Intensity adjustment
Switch /timing selector
Electrical pulse massage
Increase intensity
Decrease intensity
Heat moxibustion
LCD display
◆Moisten the skin of the neck or apply gel to the surface of
the steel electrodes prior to use.
◆If there’re sweat stains on the cervical area, clean it before use.
◆When the massager detects dry skin, the massager will limit
the intensity of the pulse massage and give an alert (8
continuous beeps) until the skin is not dry, to avoid stinging.
• Modes 1-6 are available by pressing the " " pulse mode key.
time
pulse
heat
Ievel
