OPERATION OF THE HEATER
Note
：
It is normal when the heaters are turned on for the first time or when they are turned on
after having been used for a long period of time the heaters may emit some smell and fumes.This
willdisappear when the heater has been on a short while.
Choose a suitable location for the heater
，
taking into account the safety instructions above.
Insert the plug of the heater into a suitable socket.
Turn the thermostat knob fully in a clockwise directions to the maximum setting.
Turn on the heating elements by means of the rocker switches on the side panel. When the heating
elements are on the switches will illuminate. For maximum heat output both switches should be
on.
When the desired room temperature has been reached
，
the thermostat knob should be turned
slowly anti-clockwise until the thermostat is heard to click off and the lights on the elements
switches are seen to go out. After this the heater will keep the air temperature in the room at the
set temperature by switching on and off automatically.
CLEANING THE HEATER
Always un-plug the heater from the wall socket and allow it to cool down before cleaning.
Clean the outside of the heater by wiping with a damp cloth and buff with a dry cloth.
Do not use any detergents or abrasives and do not allow any water to enter the heater.
STORING THE HEATER
When the heater is not used for long period of time it should be protected from dust and stored in
a clean dry place.
Waste electrical and electronic equipment are a special waste
category, collection, storage, transport, treatment and recycling are
important because they can avoid environmental pollution and are
harmful to health. Submitting waste electrical and electronic equipment
to special collection centers makes the waste to be recycled properly and
protecting the environment. Do not forget! Each electric appliance that
arrives at the landfill, the field, pollutes the environment!
Importer & distributor:
SC VITACOM ELECTRONICS SRL
CIF: RO 214527
Tel. 0264-438401*
