For users
- 4 -
2. Operations
2.1. Notice before using
①
The user is advised to start the water pump before the heat pump, and turn off the
heat pump before the water pump for long life circle.
②
Check firstly for any water leakage of piping connection, then power on, press the
ON/OFF button of the heat pump, and set suitable temperature.
2.2. Operation instructions
Symbol
Designation
Operation
Power ON/OFF
Press to power on or off the heat pump
Mode
Press to select Smart/Silence mode
Up/ Down
Press to set desired water temperature
Note:
①
You may set the desired water temperature from 18 to 35
℃
.
②
The
on the right shows the inlet water temperature. The
on the left shows the
set temperature by pressing buttons at the same time.
③
After you turn on the heat pump, the fan will start to run in 3 minutes. In another 30
seconds, the compressor will start to run.
④
During heating, the
will be light.
