welldana Water Tech Pool Blaster, Operator'S Manual

4

1. Remove the set of 8 AA batteries

that are attached to the underside of

the unit.

2. Remove the 2 screws that hold

the cover of the battery chamber and

carefully remove the battery holder

that is attached to the wire terminal

connector.

3. Install batteries into the holder as

shown.  Assure the battery holder

and wire terminal are connected.

Orient the battery holder and wire

terminal to the right side of battery

compartment, as shown in Fig. 1.

4. Insert the batteries into the battery

chamber, as shown in Fig. 2 and

Fig. 3.

5. The battery pack must sit deep

into the case. Not doing so will lead

to damaging leakage during use.

6. Place the rubber gasket on the

battery chamber cover, as shown

in Fig. 5.

7. Replace the battery chamber lid

and tighten the screws.

Caution:

DO NOT OVER-TIGHTEN

THE SCREWS.

English

SETTING UP THE POOL BLASTER LEAF VAC

Installing the batteries

Pole Adapter

Secure the 2 yellow pins to 

fasten the adapter in place 

as shown.

2. Secure the bag in

place by squeezing the

spring-loaded plastic slide.

Pull on the cord until the

bag tighten beneath the

yellow collar.

Debris Bag

Attaching the Pool Pole

Slide your pool pole on to the adapter until the plastic clip 

snaps into place on the pole.

1. Place the mouth of the

bag over the yellow collar

on the Leaf Vac.

Note:

While cleaning, leaves may settle around the propeller 

reducing cleaning effectiveness. Should this occur, just 

shake the Leaf Vac back and forth to dislodge the settling 

leaves and continue cleaning.

        Warning:

Do not mix old and new batteries.

Do not mix Alkaline, Carbon-Zinc, or 

Ni-Cad batteries.

        Warning:

Do NOT install Lithium-ion or 

rechargeable batteries in the

battery case.