welldana Water Tech Pool Blaster, Operator'S Manual

5

USING THE POOL BLASTER LEAF VAC

Press the ON/OFF button on the battery box to start the Leaf 

Vac.  Using the pool pole, lift the Leaf Vac into the pool and 

guide it to the pool bottom in the “Wheels Down” position.

For Bottom Cleaning

For Surface Cleaning

Push the pole adapter down 

until the adapter locks in place.  

Turn the cleaner “ON.”

The Leaf Vac may now be used 

in the “Wheels Up” position to 

skim leaves and other floating 

debris from the pool’s surface.

Adjusting the Clearance Height

The Leaf Vac is packaged 

with its clearance height in the 

“LOW” position.

The height of the Leaf Vac 

can be raised up to 1/4 inch if 

needed by doing the following:

1. Use a small screwdriver or

pair of needle-nose pliers to

remove the “E”-clip from the

top of the wheel pivot shaft.

2. Remove the wheel pivot

shaft assembly. Don’t lose the

“E” - clip and spacer.

(see Photo).

3. Place the spacer on the

pivot shaft and guide the

shaft back into the body from

beneath.

4. Replace the “E”-clip on the

top of the shaft.

Repeat these procedures on 

the remaining 2 wheel pivot 

assemblies.

Maintenance

ALWAYS clean out the debris bag following each use and 

carefully remove any debris that might be stuck in the 

propeller area of the cleaner.

Remove the batteries from the battery box prior to long-term 

storage (ie. at the end of the pool season).

IMPORTANT SAFEGUARDS

1. Extreme care must be taken to avoid fingers,

toes, hair or any other body part from coming in

contact with the Impeller while the unit

is operating.

2. Operation of this unit by children and/or

persons of diminished physical or mental

capacity is not recommended unless they are

closely supervised by an authorized adult.

3. Always check the battery box cap to make

sure that it is completely closed before each

use.  If water enters the battery box, it can

damage the unit but is not considered a

health hazard.

Filter Bag

P11AX022AP

Filter Ring

LVAC056

Leaf Vac Body

11A0000

Wheel Assembly

P11A050LV

Battery Chamber Assembly

P11A015LV

Pole Adapter Assembly

P11A061LV