27
7. Scope of supply
WAD 101
PUD 101
Control Unit
Control Unit
Hot Air Soldering Tool HAP 1
Operating Instructions
Holder KH 27
3.5 mm Jack Plug
Service Set
Mains Cable
Operating Instructions
3.5 mm Jack Plug
Hot Gas Nozzle
Mains Cable
Figure: HAP 1 Nozzle Range, see page 60 + 61
Figure: Circuit Diagram, see page 62
Figure: Exploded Diagram, see page 63
8. Warnings
1. The power cord may be inserted in approved power sockets or adapters only.
2. Keep your work area in proper order.
Always return the soldering tool to its original holder when not in use. Do not bring
combustible materials near the hot soldering tools.
3. Take care for the surroundings.
Don't use the soldering tool in a moist or wet environment.
4. Protect yourself against electrical shocks.
Avoid touching grounded parts with your body, e.g. pipes, heating radiators, stoves,
refrigerators.
5. Keep children at a distance.
Don't allow other persons to touch or disturb the soldering tool or cord. Keep other
persons away from your work area.
6. Store your soldering tool in an appropriate place.
Unused soldering tools should be stored in a dry location which is out of the reach of
children (some place high or in a locked cabinet). Switch off all unused soldering
tools.
7. Do not overload your soldering tool.
Use the soldering tool only with the specified voltage or specified pressure and
pressure range.
8. Use the appropriate soldering tool.
Don't use a soldering tool whose performance is not adequate for your work. Never
use the soldering tool for purposes for which is was not designed.
9. Wear suitable work cloths.
There is a danger of burning yourself with liquid solder. Wear the corresponding
protective clothing in order to protect yourself against burns.
10. Protect your eyes.
Wear protective eyewear. When working with bonding agents, it is particularly important
to observe the warning notices of the bonding agent manufacturer. Protect yourself
against spattering solder. There is a danger of burning yourself with liquid solder.
11. Use a soldering vapour suction device.
If devices for solder vapour suction are available, ensure that these are connected and
correctly used.
12. Do not use the cord for purposes for which it is not designed.
Never carry the soldering tool by the cord. Don't use the cord to pull the power plug
from the socket. Protect the cord from heat, oil, and sharp edges.
13. Protect the work piece.
Use clamping devices to hold the work piece in place. This is more secure than using
your hands, and leaves both hands free to work with the soldering tool.
14. Avoid abnormal posture.
Set-up your work place with proper ergonomics. Avoid bad posture when working.
Always use the suitable soldering tool.
15. Take care of your soldering tool.
Keep the soldering tool clean for better and safer work. Follow the maintenance
instructions and the notices concerning changing the soldering tips. Regularly inspect
all connected cords and hoses. Repairs should only be carried out by a qualified
technician. Use only original WELLER replacement parts.
