WHP-300-Man-4p.doc
Page 3
12/31/2002
AlanD
Page 3
12/31/2002
Soft-grounded: With plug and soldered resistance. Grounding with set
resistance value.
Notes on Use
The good thermal insulation of the Heating Plate HP 300 with respect to
the exterior makes it suitable for recessed table mounting.
Warning: Danger of skin burns! Use a suitable covering device as a
safeguard against burns. Ensure adequate circulation of air from below
when operating the heating plate in recessed table installation.
When preheating ceramic carrier material it is advisable to use a thin
Teflon or Capton intermediate layer on the heating plate to prevent
return of soldering heat to the heating plate.
Safety Instructions
The manufacturer cannot take over any responsibility or liability for
damage or injury caused by unauthorised tampering or by usage deviating
from the proper usage as described in the operating instructions.
These operating instructions and the warnings contained therein must be
read attentively and placed clearly visible in the vicinity of the
soldering device. Failure to observe the warnings can lead to accidents
and injuries or damage to health.
The WELLER Controller Unit WHP 300 with heating plate complies with the
EC Conformity Declaration according to the basic safety stipulations of
the directives 89/336/EEC, 73/23/ EEC.
Accessories
533 161 99 Hand support 490 x 340 mm
587 017 23 External Sensor
Scope of supply
HP 300 Heating Plate L x W x H: 220 x 160 x 45
Controller Unit WHP 300
Mains Cable
Operating Instructions
Warnings
(The Controller Unit WHP 300 with heating plate is referred to as the soldering tool in
the following warning texts).
1. Keep your work area in proper order.