6.4 Switching the temperature unit
Switching the temperature unit from "
°C to °F
" (8) or vice
versa.
1. Select the menu item "
°C / °F
" in the menu.
2. Set the temperature unit with the
-
or
+
button.
3. The display reverts to the normal temperature
if no buttons are pressed for about 2 seconds.
The stem is fitted with a sensor that monitors device use,
i.e. when the stem is inserted in the rest, the temperature is
reduced to standby temperature after 5 minutes and
switched off after 5 more minutes.
Vehicle adapter 12 V
Available as an accessory, the vehicle adapter is designed
for an on-board voltage of 12 volts and inserted into the
cigarette lighter socket. The adapter allows you to operate
the soldering station independently of a mains power
supply and charge the battery while you are on the move.
7. Care and maintenance
Your device has been designed and manufactured with
great care and should be handled with an equal degree of
care. The following recommendation are designed to help
you preserve your warranty and warranty claims.
• Store the device in a dry location. Precipitation, moisture
and all types of liquid and fluid may contain minerals
that can corrode the electronic circuits.
• Do not use or store the device in dusty or dirty
environments.
The moving parts and electronic components may be
damaged.
• Do not store the device in hot environments and protect
from sunlight. High temperatures may reduce the service
life of electronic devices, damage batteries and deform
or melt certain types of plastic.
• Do not store the device in cold environments.
When the device reaches normal temperature after use,
condensation may form inside and damage the
electronic circuits.
• Do not attempt to open the device.
• Do not drop, shake or expose the device to impacts and
bumps.
Handling the device roughly may damage internal
electronic circuits and delicate mechanical parts.
• Do not use aggressive chemicals, cleaning solvents or
cleaning agents to clean the device.
• Clean the glass front with a soft, clean, dry cloth, a
slightly moist cloth is also acceptable.
• Do not use the power pack outdoors.
These recommendations apply to your device, battery,
power pack and any accessories. If your device ceases to
function correctly, take it to your nearest authorised
customer service centre.
8. Fault messages / Fault correction
Message /
Possible
Remedy
Symptom
cause
Display "
-
"
- tip faulty
- Insert new
- Tip not
soldering tip
inserted correctly
Display "
BAT
" (10)
- Battery flat
- Charge battery
Switch on
disconnecting
switch "
I
" (6)
Display does not
- No operating -
- Switch on
function
voltage
disconnecting
(Display off)
switch "
I
" (6)
(battery
version only)
- Check mains
power supply
- Charge battery
9. Accessories
T005 22 419 99
Sponge 70 x 55 x 16 mm
(5 in pack)
T005 87 518 80
Vehicle adapter 12 V
T005 87 518 93
Power adapter
Follow the safety safety instructions for the
charging adapter.
Overview of soldering tips, page 99
Exploded drawing, see page 100
10. Disposal
Dispose of replaced device parts or old devices in
accordance with national regulations.
The symbol of the crossed-out waste bin on the product, in
the documentation or on the packaging material means that
within the European Union, electrical and electronic
products, batteries and accumulators must be deposited at
an appropriate recycling centre at the end of their useful
life. Do not dispose of these products with the unsorted
household waste.
Dispose of these product separately from other waste to
9
English
