27
Cooper Tools GmbH, Carl-Benz-Str. 2, 74354 Besigheim, P.O. Box 1351
Germany, Tel: (07143) 580-0, Fax: (07143) 580108
3.4
Changing the soldering parameters
The parameters can be changed temporarily in order to adjust the soldering process to the specific assembly
that is to be repaired. This function is possible only when the programming unit is unlocked. The stored
program location will not be changed.
The programming unit will show the
Status
display (it may be necessary to exit the active menu with the Exit
key).
The soldering parameters are changed by pressing the
PROGRAM
key.
S T E P 1
P 0 1
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
-
→
P R E H E A T T E M P .
3 0 0 ° C
The arrow keys
<
>
are used to jump between the different program parameters.
The arrow keys
∧
∨
are used to change the values.
The following parameters can be changed:
STEP 1 – STEP 3
PREHEATTEMP
Temperature of bottom heating
50°C -
400°C
NOZZLE TEMP
Nozzle temperature
50°C -
400°C
AIRFLOW
Air flow (5 – 50l/min)
10% -
100%
TIME
Time
0sec. -
999sec.
Additional
COOLING TIME
Cooling time
0sec. -
999sec.
PREHEATZONE SIZE
Size of the bottom heater
Small / Large
If the menu is exited using the
Exit
key, the soldering process can be started with different values.
Pressing the
PROGRAM
key again will store the modified values at a program location in the menu “Saving
and Loading“.
3.5
Loading and saving programs
The programming unit will show the
Status
display (it may be necessary to exit the active menu with the Exit
key).
Pressing the
PROGRAM
key
twice
will call up the menu for loading and saving programs.
P R O G R A M
P 0 5
>
L O A D
S A V E
A S
C L E A R
Program modus
Temporarily change of the
process parameters
Loading and saving
Access to the program sets
