20
Floating:
With plug
Soft grounded:
With plug and soldered resistor. Grounding via the selected
resistance.
6. Soldering instructions
For initial heating coat the soldering tip (tip can be coated
selectively) with solder. This removes oxide deposits and
impurities from the soldering tip that occur during storage.
During soldering breaks and before storing the soldering
iron, always ensure that the soldering tip is well coated with
solder. When using very low activated flux agents (no clean),
the use of ”Tip Activator” is recommended to maintain the
coating.
Dirt, foreign material or damage may not affect the transition
between the heating element/sensor and the soldering tip.
This will compromise the precision of the temperature con-
trol.
Important: always ensure the soldering tip fits properly.
Keep the heat-conducting surfaces of the heating element
and soldering tip clean.
The hot soldering tip may not come in contact with the cle-
aning sponge or plastic surfaces.
These soldering units have been adjusted for use with a
medium-sized soldering nozzle or jet. Deviations can occur
as a result of changing the tip or using other tip shapes.
7. Accessories
005 13 120 99
Pedal switch
005 13 031 99
Tip Aktivator
Soldering tips:
005 44 403 99 LT A
1.6 mm chisel
005 44 405 99 LT B
2.4 mm chisel
005 44 407 99 LT C
3.2 mm chisel
005 44 443 99 LT ALX
1.6 mm bent
005 44 442 99 LT BX
2.4 mm bent
005 44 412 99 LT H
0.8 mm chisel
005 44 420 99 LT HX
0.8 mm bent
005 44 408 99 LT F
1.2 mm round, slanted
005 44 444 99 LT BB
2.4 mm round, slanted
005 44 445 99 LT CC
3.2 mm round, slanted
8. Scope of supply
Soldering station WSF 81 D5/D8
Control unit
Feed unit
WSF P soldering iron
Small tool
Soldering iron storage
Power cord
Operating instructions
Safety Information
Subject to technical change without notice!
English
Summary of Contents for WSF 81 D5
Page 92: ...83 Circuit Diagram ...
Page 93: ...84 Explo Drawing WSF ...
