Ver. 03
User Manual
Bedal 3S
Operating Condition
3
Caution: Serious bodily injury or mechanical damage may result from
insufficient attention to or incorrect compliance with warning
messages with this symbol.
● Do not attempt to disassemble or reassemble the machine. It may cause an electric
shock or mechanical problem.
● Disconnect the power immediately if liquid or a foreign object enter the inside of the
machine.
● Do not input metal or inflammable material into the inlet.
● Remove the power cable while moving the machine.
● Where the wind is directly affected to the machine, it may cause measurement errors
due to wind, and measurement time could get longer.
● Be careful not to place objects that exceed the allowable load of the unit, as this will
cause the unit malfunction. (Even if no power is applied, overload will cause a
damage)
● Do not install the machine on the place as below.
- Near window or places exposed to direct sunlight.
- Where vibration is detected or unstable place (causing measurement errors)
- Where temperature changes suddenly or poorly ventilated.
- Places exposed to hot or cold air directly. (not office circumstance)
- Not solid enough or weak floor.
- Near excessive electromagnetic waves are generated (causing measurement errors)
- Where strong winds blow (measurement time may be increased)
● Temperature: 5℃ ~ 40℃
● Humidity: ~85%RH, Non-Condensing.
Introduction
