FXSO H.323 Gateway User Manual
Document Ver.: 2.1a
Release Sep., 2003
Copyright (c) 2002 Welltech Computer Co. Ltd.
65
because line number of FXS Line must remove prefix
number. For example, origin line number of FXS line is
1001, prefix is 100, since prefix number will be drop, once
gateway has incoming call 1001, after drop gateway prefix
100, it will search line number “1”. So line number must be
set as “1”.
-hwtype
application rom file of 37 series are the same no matter how
many ports is the module, so after user downloads the
application rom file, user can select which hardware type
is . ”0” means gateway will automatically detect the hardware
type, “1” means the hardware type is 1FXS+1FXO, “2” means
the hardware type is 2FXS+2FXO.
Note:
The default value is to auto detect hardware type. Usually it is
not necessary to change this setting. Please make sure about
your Hardware Type, Gateway may be not functional if set
wrong hardware type.
-ring
ring time for ring detection(in ms). When Gateway has
incoming call from PSTN side to FXO port, Gateway will
determine it is a ring but not noise only if it is longer than this
ring time.
Note:
In Taiwan the ring time of PSTN usually is 1000ms, so if user
set ring time longer that 1000ms, FXO port may not be able to
pick up the call from PSTN side.
-eod
It will transfer the DTMF in “#” if users disable the end of dial
function. Users have to press the key pad in “#” if the end of
dial function is enable.
-fxotype It’s for the 2nddial function. Any calls will be two-stage-dialing
if user enable this function.
4.2.12 [h323]
This command is for H.323 configuration related parameters.
-----------------------------------------------------------------------------------------------
usr/config$ h323
H.323 stack information and configuration
