Welltech Technology Co., Ltd.
70
3.2.9
Dial Group
Dial Group is used to set up the [group dialing]. To enter Group Number and set specific
members is to join this group. To change your Dial Group, click
Configuration
, and then
click the
Dial Group
table. The screen appears as follows.
Figure 3.2.9-2 Dial Group Setting
The following table describes the table in this screen
Table 3.2.9-1 Dial Group Setting
Label
Description
Group Number
Enter the Group Number. The Group number should NOT be the
same with Extension, Trunk Number, and Speed Dial Number.
All of the Numbers should be unique at ePBX40 system.
Telephone Number
Enter the Telephone Number to join this Dial Group. You can
enter multiple numbers by a “comma”, such as [101,102,103]
Ring Type
You can choose the Ring type for Dial Group; Ring All (Ring all
numbers at this group), Sequential Ring (Ring first one until
Pre-Configured maximum Ring time. If no answer this call, it
ring to next extension) and Random Ring. Extension maximum
Ring time was configured at
Section 3.2.1 IP PBX
PBX
Setting
Ext Ring Time
.
Dial Group End To
This feature decides the final destination if there is not anyone
of group answered this call. You can select IVR or a Number
(extension or PSTN number or SIP Trunk number).
Apply
Click the Apply button to save your customized settings and
exit this screen.
Cancel
Click the Cancel button to exit this screen without saving.
