51
9-1 Create Route Plan
Click Route Plan and Click new to create a new routing policy.
Figure 9-1 Route Plan setting
Incoming Call Type: Incoming call type
VOIP: The incoming SIP call type
FXO: The PSTN incoming call type
Matched Prefix: matched DNIS (called number) prefix
Matched Incoming List: matched DNIS incoming interface target
For VOIP incoming call type, the incoming target will be
the SIP trunk ID. Only the call from the selected SIP
Trunk will be accepted for this route.
For PSTN incoming call type, the incoming target will be
the line ID (L1 to L24). Only the call is coming from the
selected line will be accepted for this route.
Matched Length: matched DNIS (called number) length. For ignoring
the length, please set to 0.
No Answer Timeout: How long the hunting will continue to next
when the called target doesn’t answer.
Create Route Plan>Primary Route
Outgoing Type: Outgoing call type (FXO or VOIP)
Hunting Type: The hunting method will be used for this route.
Priority Ring: The call will be hunted based on the
routing list order one by one.
Cyclic Ring: The call will be hunted based on the cyclic
Summary of Contents for WellGate 2540
Page 1: ...Welltech 2540 FXO Gateway User Guide...
Page 59: ...59 4 copy firmware successfully 5 reboot 7 Check whether the system was recovered or not...
Page 77: ...77 Figure 23 Three options of Caller ID Mode...
Page 79: ...79 Figure 25 Loop Current Drop to release FXO port Figure 26 Loop Current Drop detection Time...
