Parameter description:
Port :
The logical port for the settings contained in the same row. Click on the port number in
order to configure the schedulers.
Mode :
Shows the scheduling mode for this port.
Weight (Qn) :
Shows the weight for this queue and port.
Scheduler Mode :
Controls whether the scheduler mode is "Strict Priority" or "Weighted" on this switch port.
Queue Shaper Enable :
Controls whether the queue shaper is enabled for this queue on this switch port.
Queue Shaper Rate :
Controls the rate for the queue shaper. The default value is
?
. This value is restricted to
?
-
1000000 when the "Unit" is "kbps", and it is restricted to 1-
?
when the "Unit" is "Mbps.
Queue Shaper Unit :
Controls the unit of measure for the queue shaper rate as "kbps" or "Mbps". The default
value is "kbps".
Queue Shaper Excess :
Controls whether the queue is allowed to use excess bandwidth.
Queue Scheduler Weight :
Controls the weight for this queue. The default value is "17". This value is restricted to 1-
100. This parameter is only shown if "Scheduler Mode" is set to "Weighted".
Queue Scheduler Percent :
If you select the scheduler
mode with wighted then
the screen will change as
the figure.
