5
Owner’s Manual
WPD-120
Installati on
MOVING THE UNIT
PLUGGING IN THE UNIT
Unlock the casters and push the unit using the side handles to a fl at, level surface and set the
caster brakes to the locked positi on.
Check the prongs and surface of the power cord plug for dust/dirt. If dust and/or dirt are pres-
ent, wipe off with a clean, dry cloth.
Check the power cord, plug and prongs for damage or excess play.
If any damage or excess play is found, contact a qualifi ed repair technician or a qualifi ed electri-
cian to perform replacement or repair of the power cord, plug or prongs.
NOTE: Make sure the air vent is free of dirt, dust, oil, water, or any other foreign material.
The unit is equipped with an approved NEMA plug confi gurati on. (WPD-120: 5-15P)
The appropriate outlet must be used for each plug type.
WARNINGS REGARDING PROPER LOCATION FOR INSTALLATION
Do not use the unit in explosive environments or in areas where fl ammable
gas leakage may occur.
Do not use the unit in areas where it will be exposed to rain or water.
Do not use the unit in a corrosive atmosphere.
Do not use the unit above 5°C(41°F) ~ 35°C(95°F).
Do not install the unit on uneven or sloping surface. The unit may roll or
topple over even if the casters are set to the locked positi on.
If the power cord or plug is damaged, repair should only be performed by
qualifi ed electrical personnel.
Do not connect / disconnect the power cord or att empt to operate butt ons
with wet hands. This could result in electrical shock.
