or death because of asphyxiation or carbon
monoxide.
can occur.
Move the product at a minimum of 3 m (10
tank before a start.
Do not put too much fuel in the fuel tank.
Make sure that a leak cannot occur when
you move the product or fuel container.
Do not put the product or a fuel container
light. Make sure that the storage area does
Only use approved containers when you
move the fuel or put the fuel into storage.
Empty the fuel tank before long-term
storage. Obey the local law on where to
dispose fuel.
Clean the product before long-term
storage.
Remove the spark plug cable before you
put the product into storage to make sure
that the engine does not start accidentally.
Safety instructions for maintenance
Disconnect the spark plug before doing
carburetor adjustments. .
Make sure the saw chain stops moving
when the throttle trigger is released.
oil or fuel mixture.
Keep caps and fasteners correctly
tightened.
Replacement components that are not
approved or the removal of safety devices
can cause damage to the product. This can
also cause possible injury to the operator
or bystanders. Only use accessories and
replacement parts as recommended. Do
not change your product.
Keep the saw chain sharp and clean for
safe and high performance.
Obey the instructions for lubricating and
changing accessories.
Examine the product for damaged parts.
the damaged guard or part operates
correctly. Examine for broken or incorrectly
freely. Examine for other conditions that
product. Make sure the product is correctly
installed. A guard or other damaged part
must be repaired or replaced by an
approved dealer unless written in the
operator’s manual.
children.
During transportation or storage of the
to move the product.
Do not use waste oil. Waste oil can be
dangerous to you and can cause damage
to the product and environment.
11
15.Run 10 seconds at normal idle speed.
16.Pull the throttle trigger slowly but fully for 5
release.
18
17.Use the product.
Cylinder
Table
Fuel
When you pull the trigger-it turns o .
The engine doestn’t start
1. Examine the switch button position
2. Examine the choke position
Cylinder cleaning
d. Remove the spark plug .
e. Turn the machine upside down .
f. Pull the starting rope(5-8times) to let the
g. Put back all the parts.
Note:
Make sure the fuel doesn’t spill on you body.
4. Go back step 1 start again
1. Examine the choke position(fully close).
4. Idle adjustment screw (T)
Use Idle screwdriver to turn the idle adjustment
screw 1/4 to 1/2 turn anticlockwise.
5. Start the engine again .
3. Examine the saw chain.
Make sure chain still in the drive sprocket
Engin runs but the chain is not running
2. Examine the choke position(fully close).
3. Examine the saw chain.
Make sure chain still in the drive sprocket.
Make sure chain turn easily by hand.
Engine runs but clutch cover smokes
2. Examine the saw chain
Make sure chain still in the drive sprocket.
The drive sprocket will melt turbine
The brake spring will melt clutch
To lubricate the cutting equipment
To do a check of the saw chain lubrication
Do a check of the chain saw lubrication each
time you refuel.
1. Point the nose of the guide bar at a light
color surface almost 20 cm (8 in) away.
2.
shows on the light surface.
Cylinder ooded
3. If you cannot see the line of oil after 1
bar. Clean the groove in the edge of the
guide bar. Make sure the guide bar nose
sprocket turns freely and that there are no
blockages in the lubrication hole. Clean
and lubricate the tip sprocket.
Idle Adjustment Screw
T