6. Make sure that the edges of the cutting
links are turned forward on the top edge of
the guide bar.
8. Make sure that the drive links of the saw
Also make sure that the saw chain is
guide bar.
9.
Chain Drive
Links
Chain
Rotation
Cutters
10.
tensioning screw clockwise with the
. Tighten the saw chain until it does not sag
13
it
hand .
7. Assemble the clutch cover and steer the
chain adjuster pin to the hole in the guide
bar.
Chain-tensioning
Pin Hole
Drive
Sprocket
Clutch
combination wrench
Bar Nuts
Clutch cover
Chain-tensioning Screw
CAUTION:
Do not use gasoline
with an octane number less than
90 RON (87 AKI). This can cause
damage to the product.
Note:
Use gasoline with a higher octane
3.
oil to the fuel container.
CAUTION:
damage to the product.
4. Shake the fuel mixture to mix the contents.
5.
fuel container.
6. Shake the fuel mixture to mix the contents.
7. Fill the fuel tank of the product with the fuel
mixture.
.
To ll the fuel tank
1. Make sure that the fuel mixture is correct
and that the fuel mixture is in a fuel
container with an antispill valve.
2. If fuel is on the container, remove the
3. Make sure that the area near the fuel tank
cap is clean.
4. Remove the fuel tank cap.
5.
the fuel mixture to the fuel tank.
6. Put back the fuel tank cap.
To lubricate the saw chain
The product has an automatic lubrication
tank are designed so that the fuel runs out
1. Use vegetable-based saw chain oil or a
standard chain oil.
2. Make sure that the area near the cap of the
saw chain oil tank is clean.
3. Remove the cap of the saw chain oil tank.
4. Fill the saw chain oil tank with the
recommended saw chain oil.
5. Put back the cap of the saw chain oil tank.
To start and stop
Before ou start the engine
Examine the product for missing, damaged,
loose or worn parts.
Examine the nuts, screws and bolts.
Examine the trigger lockout and the trigger
for correct operation.
Examine the stop switch for correct
operation.
Examine the product for fuel leaks.
Examine the saw chain sharpness and
tension.
To start a cold engine
16
1. Move the front hand guard forward to
engage the chain brake.
2.Open the switch button(1 open /0 stop).
switch button