Wemars WS-ST42G, Instructions Manual

A

B

• Use protective boots with steel toes and non-slip

soles.

• Use clothing made of a strong fabric. Always use

heavy, long pants and long sleeves. Do not use

loose clothing that can catch on twigs and branches.

Do not wear jewelry, short pants, sandals or go with

bare feet. Put your hair up safely above shoulder

level.

06

• Keep first aid equipment close at hand.

Safety devices on the product

WARNING: Read the warning instructions

that follow before you use the product.

In this section the product’s safety features, its purpose

and how checks and maintenance should be carried out

to ensure that it operates correctly. See instructions

under the heading  to find 

where

these

parts

are

located

on your product.
The life span of the product can be reduced and the risk

of accidents can increase if product maintenance is not

carried out correctly and if service and/or repairs are not

carried out professionally. If you need further information

please contact 

Wemars service 

.

WARNING: Never use a product with

defective safety components. The product's

safety equipment must be inspected and

maintained as described in this section. If

your product fails any of these checks,

contact 

Wemars

service

 to get it repaired.

CAUTION: All servicing and repair work on

the machine requires special training. This is

especially true of the machine′s safety

equipment. If your machine fails any of the

checks described below you must contact

Wemars

 service . 

To do a check of the throttle trigger lockout
The throttle lockout is designed to prevent accidental

operation of the throttle control.

1. Press the throttle trigger lockout (A) and make sure

that the throttle 

trigger

 (B) is released . When you

release the handle the throttle control and the throttle

trigger lockout both move back to their initial

positions. This movement is controlled by two

independent return springs. This arrangement

means that the throttle control is automatically

locked at the idle setting.

2. Make sure that the throttle 

trigger

 is locked at the

idle setting when the throttle trigger lockout is

released.

3. Press the throttle trigger lockout and make sure that

it returns to its intial position when you release it.

B

Ａ