INSTRUCTION MANUAL
MODEL 413CV
ÉTAU POUR PERCEUSE
3-1/2-INCH
CROSS VISE
PARTS
Fig. 1
Top View
Fig. 2
Top View
ASSEMBLY
1. Remove all components and parts from the box. Your cross vise includes the following
hardware:
• (3) Hex Wrenches
• (2) Locking Nuts
• (2) Flat Washers
• (2) Crank Handles
2. If necessary, adjust the longitudinal (top) feed screw until the handle-mounting portion of
the feed screw protrudes beyond the vise body, as shown in Fig. 1 below. Turning the feed
screw clockwise retracts it; turning it counterclockwise advances it. Turn the feed screw fully
clockwise until it can no longer retract.
3. Mount one of the crank handles on the leadscrew, as shown in Fig. 2 below.
4.
Secure the crank handle to the feed screw using the included flat washer and locking nut (Fig.
2). Tighten the nut (turning clockwise) against the handle using a 10 mm socket (not included),
then back it off a quarter turn (turning counterclockwise). Turn the handle a couple of times. If
it is difficult to turn, loosen the nut. Adjust the nut as necessary to ensure that the handle turns
smoothly and advances the slide properly.
5. Repeat the same procedure to mount the remaining crank handle on the cross feed screw.
Crank Handle
Feed Screw
Flat Washer
Locking Nut
Clockwise Brings
Feed Screw Out
Counterclockwise
Sends Feed Screw
In
No.
Part No.
Description
Qty.
1
413CV-001
Base
1
2
413CV-002
Nut
1
3
413CV-003
Saddle
1
4
413CV-004
Gib
2
5
413CV-005
Hex Nut, M6
6
6
413CV-006
Set Screw, M6x15
4
7
413CV-007
Flat Washer, M6
2
8
413CV-008
Longitudinal
Feed Screw
1
9
413CV-009
Cross Feed
Screw
1
10
413CV-010
Retaining Plate
1
11
413CV-011
Socket Head Bolt,
M6x16
4
12
413CV-012
Crank Handle
Assembly
2
No.
Part No.
Description
Qty.
13
413CV-013
Locking Nut, M6
2
14
413CV-014
Leadscrew With
Handle
1
15
413CV-015
Guide Rod
1
16
413CV-016
Body
1
17
413CV-017
Socket Head Bolt,
M6x12
4
18
413CV-018
Movable Jaw
1
19
413CV-019
Dog Point Set
Screw, M6x10
1
20
413CV-020
Jaw Plate
1
21
413CV-021
Grooved Jaw
Plate
1
22
413CV-022
Retaining Plate
1
23
413CV-023
Set Screw, M6x20
2
24
413CV-024
Lock Washer, M6
4
13 7
11
17
17
11
12
24
24
22
10
8
4
21
20
18
14
15
6
5 23
23
5
3
2
16
1
4
6
19
9
12
13
7
Compatible with WEN Drill Press:
4210, 4212, 4214, 4225, 4227
