3
GENERAL SAFETY RULES
Safety is a combination of common sense, staying alert and knowing how your item works.
SAVE THESE SAFE-
TY INSTRUCTIONS.
WARNING:
To avoid mistakes and serious injury, do not use your item until the following steps
have been read and understood. These safety rules cannot address every possible scenario you may
encounter, so please use common sense and caution when using the item.
1. READ and become familiar with this entire instruction manual. LEARN the tool’s applications, limitations, and
possible hazards.
2. KEEP WORK AREA CLEAN. Cluttered areas invite injuries and accidents.
3. OBSERVE work area conditions. Keep work area well lit.
4. ALWAYS keep your work area clean, uncluttered, and well lit. DO NOT work on floor surfaces that are slippery
with sawdust or wax.
5. STORE IDLE EQUIPMENT. When not in use, store this item n a safe and clean location. Always secure prod-
ucts and keep out of reach of children.
6. USE THE RIGHT PRODUCT FOR THE JOB. There are certain applications for which this item was de-
signed. Do not modify it and do not use it for a purpose for which it was not intended.
7. CHECK FOR DAMAGED PARTS. Before using any product, any part that appears damaged should be care-
fully checked to determine that it will operate properly and perform its intended function. Check for any broken
or damaged parts and any other conditions that may affect its operation. Replace or repair damaged or worn parts
immediately.
8. WHEN SERVICING use only identical replacement parts and accessories. Using any other parts will void the
warranty.
9. DO NOT operate the tool if you are under the influence of drugs, alcohol, or medication that may affect your
ability to properly use the tool.
10. USE EYE PROTECTION. Always wear ANSI approved impact safety goggles during assembly.
11. DO NOT EXCEED THE PRODUCT’S MAXIMUM LOAD CAPACITY. Always keep weight evenly dis-
tributed.
12. ONLY USE ON A FLAT SURFACE capable of supporting the item with its maximum capacity load. It is easy
to lose control if attempting to pull a load on a sloping or uneven surface.
13. DO NOT ALLOW CHILDREN TO PLAY ON, stand upon or climb on this item. It is not intended for car-
rying people or animals.
14. ALWAYS CHECK HARDWARE and assembled parts after assembling. All connections should be tight.
