11
INSTALL SANDING BELT TABLE
1. Pass the sanding belt through the slot on the belt table
(Fig. 2 - 1) and position the table on the machine.
2. Secure the belt table into position using the locking lever
(Fig. 2 - 2).
NOTE:
You will have to follow the instructions
below to install the locking lever before you can use it to
secure the belt table.
Install the locking lever:
1. Gather the locking lever assembly (Fig. 3 - 1) and washer
(Fig. 3 - 2).
2. Disassemble the locking lever into the three parts shown
in Fig. 4. Using the 3mm hex wrench, remove the socket
head cap screw with spring (Fig. 4 - 3) from the lever handle
(Fig. 4 - 2). This will release the lever base (Fig. 4 - 1).
3. Align the slot in the belt table (Fig. 5 - 2) with the tapped
hole (Fig. 5 - 1) in the housing located underneath the table.
4. By hand, screw the lever base (Fig. 5 - 4) and washer (Fig.
5 - 3) into the tapped hole (Fig. 5 - 1), turning clockwise.
5. Place the lever handle (Fig. 4 - 2) onto the tightened lever
base (Fig. 5 - 4). Then, re-install the socket head cap screw
and spring (Fig. 4 - 3) through the lever handle. Tighten us-
ing the 3mm hex wrench. See the final assembly in the top
right-hand corner of Fig. 5.
NOTE:
The lever is spring-loaded, and can be loosened and
re-positioned to allow you to make adjustments to the table
bevel, as desired. Always make sure the table is securely
locked down before beginning to sand.
NOTE:
Before making any adjustments check that the power switch is in the OFF position and that the plug is
disconnected from the power source.
Fig. 2
1
2
1
3
Fig. 3
Fig. 4
Fig. 5
ASSEMBLY & ADJUSTMENTS
WARNING!
Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
2
1
2
3
1
2
4
3
