Wen DW6395, Instruction Manual

ASSEMBLING THE DRYWALL SANDER

1. Connect the upper shaft (Fig. 1 - 1) and the lower shaft (Fig. 
1 - 2) of the drywall sander together by lining up the two shaft 
ends and securing the locking latches (Fig. 1 - 3) on either side 
of the shaft connection.

2. Attach the sandpaper (Fig. 2 - 1) of your choice to the face of 
the hook and loop base pad (Fig. 2 - 2). Ensure the holes on the 
sandpaper align with the holes on the bottom of the pad.

3. The use of a dust collection device is highly recommended. 
Connect the dust hose (Fig. 3 - 1) to the bottom of the unit (Fig. 
3 - 2) and then connect the other end of the dust hose directly to 
your dust collection device (Fig. 3 - 3) or use one of the provided 
dust port adapters depending on the port on your dust collection 
device.

ASSEMBLY & ADJUSTMENTS

Fig. 1 

1

1

WARNING!

 To avoid injury from accidental startups, 

turn switch OFF and remove the plug from the power source 
outlet before making any adjustments.

9

TOOL PURPOSE

Sand plastered walls, ceilings, and interior walls, as well as remove paper residues, paint layers, coatings, adhesive 
residues, and loose plaster with your WEN Drywall Sander. Refer to the diagram below to become familiarized with 
the parts and controls of your drywall sander.

KNOW YOUR DRYWALL SANDER

Power Switch

Hose Connection

Handle

Variable Speed

Motor

Hook & Loop Base Pad

Upper Shaft

Lower Shaft

Arm Locking Latch

Head Angle Lock Knob

Fig. 2 

Fig. 3 

2

2

3

3

1

2

3