15
ROUTINE INSPECTION
Before each use, inspect the general condition of the
tool. If any of these following conditions exist, do not
use until parts are replaced or the saw is properly re-
paired.
Check for:
• Loose hardware,
• Misalignment or binding of moving parts,
• Damaged cord/electrical wiring,
• Cracked or broken parts, and
• Any other condition that may affect its safe operation.
NOTE:
Electric tools used on fiberglass material, wall-
board, spackling compounds, or plaster are subject to
accelerated wear and possible premature failure because
the fiberglass chips and grindings are highly abrasive to
bearings, brushes, commutators, etc. Consequently, we
do not recommend using this tool for extended work on
these types of materials. However, if you do work with
any of these materials, it is extremely important to clean
the tool using compressed air after operation.
CLEANING & STORAGE
1. Keep the ventilation openings free from dust and de-
bris to prevent the motor from overheating.
2. Wipe the tool surfaces clean with a clean cloth. Make
sure water does not get into the tool.
Cleaning & storage continues in the next column.
MAINTENANCE
CAUTION!
Most plastics are susceptible to damage from
various types of commercial solvents. Do not use any
solvents or cleaning products that could damage the
plastic parts. Some of these include but are not limited
to: gasoline, carbon tetrachloride, chlorinated cleaning
solvents, and household detergents that contain ammo-
nia.
3. Store the tool in a clean and dry place away from the
reach of children. Store in temperatures between 41° to
86°F.
4. Cover the Spindle Sander in order to protect it from
dust and moisture. It is preferable to store it in its origi-
nal packaging with the instruction manual and all acces-
sories.
PRODUCT DISPOSAL
Used power tools should not be disposed of together
with household waste. This product contains electronic
components that should be recycled. Please take this
product to your local recycling facility for responsible
disposal and to minimize its environmental impact.
Please recycle the packaging and electronic
components where facilities exist.
WARNING!
To avoid accidents, turn OFF and unplug the tool from the electrical outlet before cleaning,
adjusting, or performing any maintenance work. .
WARNING!
Any attempt to repair or replace electrical parts on this tool may be hazardous. Servicing of the
tool must be performed by a qualified technician. When servicing, use only identical WEN replacement parts.
Use of other parts may be hazardous or induce product failure.
Summary of Contents for HA5932
Page 19: ...19 NOTES ...
Page 20: ...THANKS FOR REMEMBERING ...