8
99
ELECTRICAL INFORMATION
AMPERAGE
REQUIRED GAUGE FOR EXTENSION CORDS
25 ft.
50 ft.
100 ft.
150 ft.
11A
16 gauge
16 gauge
14 gauge
12 gauge
GUIDELINES AND RECOMMENDATIONS FOR EXTENSION CORDS
When using an extension cord, be sure to use one heavy enough to carry the current your product will draw. An
undersized cord will cause a drop in line voltage resulting in loss of power and overheating. The table below shows
the correct size to be used according to cord length and ampere rating. When in doubt, use a heavier cord. The
smaller the gauge number, the heavier the cord.
NOTE:
"Amperage" below refers to the current that the starter mo-
tor draws.
1.
Examine extension cord before use.
Make sure your extension cord is properly wired and in good condition.
Always replace a damaged extension cord or have it repaired by a qualified person before using it.
2.
Do not abuse extension cord.
Do not pull on cord to disconnect from receptacle; always disconnect by pulling
on plug. Disconnect the extension cord from the receptacle before disconnecting the product from the extension
cord. Protect your extension cords from sharp objects, excessive heat and damp/wet areas.
3.
Use a separate electrical circuit for your tool.
This circuit must not be less than a 12-gauge wire and should
be protected with a 15A time-delayed fuse. Before connecting the motor to the power line, make sure the switch
is in the OFF position and the electric current is rated the same as the current stamped on the motor nameplate.
Running at a lower voltage will damage the motor.
TIP:
WEN offers 12-gauge, outdoor-rated, grounded three-wire extension cords in 50-foot and 100-foot lengths
(Model No's. PC1123 & PC5124), available for purchase at
wenproducts.com
.
UNPACKING
With the help of a friend or trustworthy foe, carefully remove the snow blower from the packaging and place it on
a sturdy, flat surface. Make sure to take out all contents and accessories. Do not discard the packaging until every-
thing is removed. Check the packing list on the next page to make sure you have all of the parts and accessories.
If any part is missing or broken, please contact our customer service at
1-800-232-1195
(M-F 8-5 CST), or email
techsupport@wenproducts.com
.
TRANSPORTING
To prevent fuel spillage when transporting, be sure to perform the following steps:
UNPACKING & TRANSPORTATION
WARNING!
Do not plug in or turn on the tool until it is fully assembled according to the instructions. Failure
to follow the safety instructions may result in serious personal injury.
1. Tighten the fuel cap and turn the fuel valve to the
OFF position.
2. Remove the engine key and store it in a safe place.
3. Drain the fuel tank if possible. Refer to "Draining
The Fuel Tank" on page 27.
4. Keep the snow blower upright. Never place the
snow blower on its side or upside down - doing
so could damage the internal components of the
engine and make it difficult to start.
