12
S
TEP
A
SSEMBLY
1. Remove the four Wing Nuts from each of the four Steps
and set them aside.
Note: Do not discard the Wing Nuts, they will used
to attach the Steps to the Riser.
2. Start with the longest Step at the top and place the
Steps on the Stringer Assemblies in descending
order with the widest end at the rear as shown.
Fit the threaded studs in the proper holes in the
Stringer Assembly.
3. Secure the Steps using the Wing Nuts.
Turn the Wing Nuts as tight as possible
by hand (or gently using a pliers).
S
AFETY
C
HECK
With the riser in the Performance Position,
check the fasteners for tightness:
a. Six Locking Nuts on the Chassis.
b. Ten Screws securing the Back Rail Upright Tubes.
c. Six Locking Nuts on the Back Rail Horizontal Tubes.
d. Sixteen plastic Wing Nuts (four under each Step).
A
SSEMBLY
CONTINUED
Wing
Nuts
Completed Step,
Back Rail and
Chassis Assembly
