14
Risers can be connected to additional units using the Unit Connector Brackets installed on the Steps.
To connect risers together:
1. Roll an additional riser to be aligned as close as possible with the riser already placed in the
Performance Position.
2. Unfold the riser into the Performance Position, setting the Rear Step onto the Rear Bracket of the
already placed riser.
3. Lift the Front Step of the already placed riser over the Front Bracket of the additional riser.
4. If necessary, shift the positioning of the connected risers to fit tightly together.
C
ONNECTING
M
ULTIPLE
R
ISER
U
NITS
Front
Bracket
Rear
Bracket
Adjoining risers can separate
during use unless they are
connected using the attached
Unit Connector Brackets.
!
WARNING
Unused Unit Connector
Brackets can cause injury.
!
CAUTION
Unused Unit
Connector
Bracket
Unused Unit
Connector
Bracket
