8
C
HASSIS
A
SSEMBLY
1. Remove the Chassis Assembly, two Stringer Assemblies, and Hardware Pack from the carton.
Place the Chassis Assembly (wheels down) on the floor.
2. Rotate the Link Bars to the backside of the
Chassis Assembly.
3. Cut and remove the plastic shipping
bands and rotate the Truss and the
Truss Support to align with the
holes in the Chassis Assembly as shown.
4. Insert a 3/8” x 1” Carriage Bolt through
both of the aligned holes from the
underside of the Chassis Assembly
the Truss Support.
Secure both Carriage Bolts with a
3/8” Locking Nut.
5. Place both Stringer Assemblies on the threaded studs
of the Chassis Assembly.
6. Place a 5/8” x 3/4” Sleeve over each of the four threaded studs.
7. Secure the Stringer Assemblies and Sleeves using a
3/8” Locking Nut on each of the four threaded studs.
Tighten the Locking Nuts securely.
A
SSEMBLY
Truss
Locking
Nut
Chassis
Assembly
Truss
Support
Carriage
Bolt
Align
Holes
Stringer
Assembly
Sleeve
Locking
Nut
Completed
Chassis Assembly
Rotate
Link Bar
Threaded
Stud